The resistant oil system dehydration filter element TX-80 is a dehydration filter element used in the regeneration device of the fire resistant oil system in power plants. The following are specific instructions for the usage process and installation precautions:

Usage process:

Preparation: Before replacing the filter element, ensure that the working area is clean and have the necessary tools and materials ready.

Shut down the system: Before replacing the filter element, it is necessary to shut down the fire-resistant fuel system and ensure that the relevant valves or switches are in a closed state.

Disassembling the old filter element: Use appropriate tools and follow the equipment's operating manual or relevant instructions to remove the old filter element. Be careful to avoid splashing out of liquids or pollutants in the filter element.

Clean the filter cartridge seat: Clean the filter cartridge seat, remove any residue from the old filter cartridge, and ensure that the seat surface is flat, free from residue and damage.

Install a new filter element: Place the new filter element into the filter element holder and ensure that it is installed correctly and securely. Depending on the equipment requirements, it may be necessary to apply appropriate lubricant to the filter element.

Starting the system: After completing the replacement of the filter element, open the valve or switch of the fire-resistant fuel system, start the system, and conduct necessary tests and inspections to ensure the normal operation and sealing of the filter element.

Installation precautions:

Safe operation: During the operation process, ensure that relevant safety operation procedures are followed to avoid accidents or injuries.

Standardized accessories: Use standardized filter element accessories and ensure that they match the specifications and requirements of the equipment. Avoid using non-standard or low-quality accessories to avoid affecting the performance of the filter element and the normal operation of the system.

Prescribed replacement cycle: Determine the filter element replacement cycle according to the equipment operation manual or manufacturer's recommendations, and strictly follow the specified time for replacement. Avoid delaying replacement, resulting in filter element failure or reducing its filtration efficiency.

Filter element marking: After replacing the filter element, promptly mark the replacement time and status of the filter element. This can track maintenance records and maintain good management of the system.

In summary, when using the TX-80 filter element as the dehydration filter element for the regeneration device of the power plant's fire-resistant oil system, it is necessary to strictly follow the installation steps and pay attention to installation precautions to ensure the effective operation of the filter element and the normal operation of the system. If necessary, it is recommended to refer to the equipment operation manual or consult relevant professionals.

 

 

Filter element WU-6300*1200

generator stator cooling water filter SG65/0.7

EH oil main pump suction filter HQ25.200.11Z

generator stator cooling water filter KLS-100I

Recycle pump washing filter DP1A401EA01V/-F

lube filter LY-38/25W

generator stator cooling water filter SL-12/50

generator stator cooling water filter MSL-125

Coarse filter CLX-75

Circulating oil pump oil-return working filter DP405EA03V/-W

actuator flushing filter DP6SH201EA01V/F

actuator filter with o-ring DP201EA03V/-W

generator stator cooling water filter MSL-31

generator stator cooling water system Y-type filter back-flushing cartridge KLS-125T/60

regeneration oil pump suction filter HQ25.300.12Z

dehydration filter TX-80

oil pump filter DP602EA03V/-W

gas turbine actuator filter CB13299-002V

pEH pump working filter AP3E301-02D03V/-W

EH pump flushing filter DP1A601EA01V/-F

oil pump suction filter JCAJ007

gas turbine actuator filter CB13300-001V

jacking oil pump suction filter 707FM1641GA20DN50H1.5F1C

Circulating oil pump suction filter OF3-08-3RV-10

Filter disc SPL-15

lube filter LY-10/10W-40

Filter element CRA110CD1

DFYLSYC-2023-06-25-A