The luber Fuel oil filter element  SDGLQ-2T-100K is used to filter out the sundries in the fuel, and has the advantages of good passing performance, high filtration efficiency, simple structure, low cost, and easy maintenance.

The replacement cycle of the luber Fuel oil filter element  SDGLQ-2T-100K is generally determined according to the service conditions. Generally, it needs to be replaced when the amount of lubricating oil reaches a certain level or the pressure difference of the filter element is large. It should be noted that when replacing the filter element, be sure to choose a filter element that meets the specifications and quality requirements, and replace and install it according to the instructions for use. At the same time, when replacing the filter element, we must pay attention to the pressure and residual lubricating oil in the discharge lubricating oil system, so as to avoid pollution and damage to the equipment and the environment. "

 

 

filter FX-515*80

oil suction filter FX-515*80

filter FX-520*100

regeneration device filter 01-388-023

filter FX-520*180

filter FX-520*80

filter FX-60*10Q2

filter FX-60*20Q2

filter FX-60*30Q2

filter FX-60*3Q3

filter FX-60*5Q3

filter FX-630*40H

lube filter FX-630*40H

inlet filter FX-76*5H

filter 0140D003BH3HC

filter FX-850*40H

deacidification filter (EH oil station filter) GDHR5211HP0721-V

filter GDY691

cellulose filter GL-900

precision filter GLX-160*800E15

jacking oil pump suction filter GLX268A/20

Coarse filter GLX-75

filter GP300*10Q2

filter GP300*20Q2

filter GP300*30Q2

filter 0140D003BN3HC

filter GP300*3Q2

DFYLSYC-2023-03-21-A